I don’t have my chameleon updated
to mk4 yet (it’s on its way to bill now) but I wanted to confirm if this is how the servo arm should be attached to the clippy for an ad5m. I printed the part from tinkercad and cut off 3 of the arms as instructed on the updates post pinned. my tolerances aren’t great so I may have to reprint. But can anyone confirm if this is correct? I’m new to using servos so not sure what to expect. Thanks!
Hey Adam. I’ve just ordered the mk4 to add to my ad5m. Any tips on install and setup
im just now going into my 3d clippy project now,wish me luck haha
It looks good, but… You're going to want to remove the servo and connect it to the 3D Chameleon control board once to initialize the servo's home position, Then you can reassemble it, assured that it won't potentially damage the Clippy.