Hello! I printed a 3DClippy for my ender 3 v2 and when assembled, the blade (correct snapoff blade from kit) does not reach far enough down to the filament to cut it. I have to lift the 3dclippy arm up to push it farther than the 3dclippy body will allow, in order to cut the filament.
I’ve tried flipping the blade and superglue on the blade but probably not in the right way
Fixed! for future readers - Had to reprint the blade holder and orient the blade correctly (there is a small slit on the angled side, meant for the blade corner to poke through. Didn't see it when I printed the 3DClippy in black)