To see this working, head to your live site.

3d Chameleon 8 Color 3d Printer Upgrade

in Support

Hello I have the 3d Chameleon 8 Color 3d Printer Upgrade and these printers:

-Artillery Hornet [Call Me Swal] Conveyor Belt Printer Mod

-Zonestar Z9V5Pro v5

-Tronxy GEMINI S

Which would you recommend to install the kit on?

Thanks!

9 comments

9 Comments

k:ai

Sep 04, 2022

So I need to open box to see if it had WiFi, are these the ones your recommended?

if so it’s install by default in Tronxy GEMINI S

k:ai

Sep 04, 2022

Replying to

Now I’m just waiting for your 3D Chameleon, I was fortunate enough to get a new set off of eBay and this awesome seller even accommodated my international shipping. I am really excited to get this going and your amazing support. Have a good restful Sunday

k:ai

Sep 04, 2022

Replying to

PS, it seems like your 8 color kit was just waiting for the right machine ;)

k:ai

Sep 20, 2022

Replying to

The USPS is "Moving Through Network

In Transit to Next Facility

September 19, 2022"

Delivery was estimated Sept 9 but seems to be taking the long way here. Will keep you posted once it arrives, and I am ready to get it installed.

Bill

Sep 02, 2022

Oh, I'd go with the Tronxy... you can use both 3D Chameleons (one on each extruder) and it'll be great. I'd recommend getting rid of those horrible Titan extruders and upgrading to the BMG style clones, however... the Titans won't load properly. When you're ready, let me know and I'll help you with the software configuration. Start off just installing one on one of the sides... then once you have it installed and tested out, just duplicate the installation on the other side. In this configuration, you can actually have both units use the same switch.

k:ai

Sep 02, 2022

Replying to

Can you send me link to which BMG style clones you prefer :)

Bill

Sep 02, 2022

Replying to

These are what I use: https://www.amazon.com/Extruder-Upgrade-extruder-Anycubic-Printer/dp/B08PYCMPVF Be sure to check out my video on any possible modifications you might need to correct a poor fitting drive gear here: https://www.youtube.com/watch?v=Whgd3YlK16E Also, I recommend confirming that the filament path through them is large enough... I use a 2mm drill bit to make sure... just hand turn it through the plastic to open it up if necessary. This is the 2mm drill kit I use if you don't have a 2mm drill already: https://www.amazon.com/Vise-Hand-Drill-Jewelry-Making/dp/B098CF3VMM

Bill

k:ai

Sep 02, 2022

Replying to

Ordered! I will get back to you when they arrive, thank you for all the quick responses and help :)