I got my Sovol Sv08 today, I was wondering, how would you go about installing the chameleon on it?
top of page
To test this feature, visit your live site.
Sovol Sv08 Chameleon installation
Sovol Sv08 Chameleon installation
4 comments
Comments (4)
bottom of page
Has anyone used this yet with an SV08 with the Sovol enclosure? The bracket as it exists today covers the hole in the enclosure for filament to enter through. That said, once I remove the spool holder and filament runout sensor to mount the 3d Chameleon, the slot designed into the printed height extender does allow for me to route the filament tubes in via that location.
Either way, I will likely remix the bracket to account for A) reuse of existing screws for the spool holder, B) access to the factory filament entrance in the side of the enclosure, C) space for the enclosure fastener in the center-top since it is not a flush/recessed screw and needs somewhere to go, unless someone else has already done so.
Hi Bill Thank you, I bought all the parts for the 3dClippy as well, i'm excited to install it. Thank you for your quick response. Out of interest sake, would you mind posting your MK4 GCode?
Download these mounts and optionally the Generic Digital 3DClippy files. It's exactly the same as any other printer otherwise.
https://www.tinkercad.com/things/bzLn4mTuQZo-sovol-sv-08-3dchameleon-mounts
Here are pics of my installation:
Bill