I've tinkered with the code quite a bit and it works pretty well aside from the occasional missed feed. I'm looking for any suggestions and examples of code to really dial it in. Thanks in advance.
top of page
To see this working, head to your live site.
10 Comments
bottom of page
So... the real question is dial what in? Are you just looking for code to dial in the loading? Can you describe the issue you're having with the occasional missed feed? Is it not loading or is it not pulling it back out through the Y adapter or some other issue? Also, is it blobbing when reloading or oozing? There are points in the gcode where you can tune the loading distances... it's always best to load a little short and allow the filament to reach the tip during the purge block, I've found. You can actually tune it very close to optimal that way.