I've looked around the forums and haven't seen anything regarding this, so I hope I'm not asking a duplicate question.
My wife has said that I can purchase my 3D Chameleon in 4 days, and I'm so excited! I'm fairly new to 3D printing, just got my first printer for Christmas (the Ender 3). I've recently learned to compile my own Marlin firmware for it, and was wondering if there were any firmware changes that could help the 3D Chameleon. I know from reading that it isn't required, but is there anything to gain there?
Meanwhile I'm off to learn PrusaSlicer because I started with Cura!
Thanks Bill!
There is nothing that the firmware does that interacts with it... everything that is done to control the 3D Chameleon is done via the gcode generated from the slicer.