Hey @Bill fantastic product, looking to add one to my Klipperised SV06 but I'm in the same boat, danged freight adds almost $100 (AUD) to the cost! Eye watering! I have an old Ender 3 8-bit board sitting in the drawer and more power supplies than you can poke a stick at, so I gather that would work? Is the BoM available anywhere? If I can get it up and running I still want to support your project via a donation because I'm interested in adding a Chameleon to any of my printers that don't currently do multi-colour.
Our board is not open source, however, you can easily just buy a simple 3D printer control board to do the same task. We use two motor controllers driving by a microcontroller... any old 8 bit 3D printer control board will perform the same task.
Hey @Bill fantastic product, looking to add one to my Klipperised SV06 but I'm in the same boat, danged freight adds almost $100 (AUD) to the cost! Eye watering! I have an old Ender 3 8-bit board sitting in the drawer and more power supplies than you can poke a stick at, so I gather that would work? Is the BoM available anywhere? If I can get it up and running I still want to support your project via a donation because I'm interested in adding a Chameleon to any of my printers that don't currently do multi-colour.
Cheers! 💪🏼
Thanks
Our board is not open source, however, you can easily just buy a simple 3D printer control board to do the same task. We use two motor controllers driving by a microcontroller... any old 8 bit 3D printer control board will perform the same task.
Bill