I've got everything setup. Question - do I have to feed it through the original extruder like in the older setup video? I saw in the newer Youtubes that on the Ender V2 the extruder was completely removed. However, I can't tell if the hotend is a direct drive. It doesn't look like it, but before I take this whole thing apart I wanted to make sure. Also, with current setup I'm getting the tips of the filament stuck in the original extruder and the colors can not swap at all. It looks like the tip expands too much and causes a clog. I'm guessing that I need to print the "Clippy" file and get that installed.
Any help you can give me would be awesome.
I have the MK2 (purchased it last may/june).
I finally have a machine that I can tinker with.
Thanks!
This is a fantastic tinker machine, definitely get the upgrade kit if you haven't and take some time figuring it out. seriously read through every post on this forum before hand too. I also have an ender 3 v2 mostly running with an advanced install (3dc as extruder with 3dclippy) and can help too, just lmk